RAMSET RA54, Operator'S Safety & Operating Instruction Manual

Page: 7 / 9

12 13
PARTS SCHEMATIC / PARTS LIST
PARTS SCHEMATIC / PARTS LIST
PARTS LIST / MAINTENANCE
PARTS LIST / MAINTENANCE
RA54 PARTS LIST
KEY P/N DESCRIPTION QTY
1 M38033 FASTENER GUIDE ASSEMBLY 1
2 011483 PISTON RETURN SPRING 1
3 011002 PISTON ISOLATION RING 1
4 37077 PISTON 8mm 1
5 011000 BARREL CIRCLIP 1
6 011004 BARREL WASHER 1
7 37006 BARREL FRONT END SPRING 1
8 M38028 BARREL RENTION COLLAR 1
9 011001 BARREL RETENTION O-RING 1
10 011003 BARREL BUFFER 1
11 38004 75mm BARREL 1
12 M37021 POWER ADJUSTMENT ASSEMBLY 1
13 28111 MECHANISM HOUSING 1
14 37027 MECH HOUSING PIN 1
15 37013 CHARGE ADVANCE LEVER SIDE SPRING 1
16 28157 FIRING PIN ASSEMBLY 1
17 28150 FIRING SPRING 1
18 M37030 SPRING GUIDE 1
19 37004 END CAP 1
RA54 PARTS LIST (continued)
KEY P/N DESCRIPTION QTY
20 37033 CAP SCREWS - M5x100 2
21 37015 COCKING ROD 1
22 37010 RECEIVER WELDMENT 1
23 M27516 TRIGGER MECHANISM PIN 1
24 27870 ROTARY SEAR PIN 1
25 M28197 ROTARY SEAR 1
26 M28161 COCKING ROD SPRING 1
27 M28132 TORQUE CAP 1
28 37017 BLACK TRIGGER ASSEMBLY 1
29 37014 CHARGE ADVANCE TENSION SPRING 1
30 M27515 TRIGGER SEAR SPRING 1
31 37016 CHARGE ADVANCE LEVER ASSEMBLY 1
32 38024 EXHAUST TUBE 1
33 37001 & 37002 OUTER HOUSING (LHS & RHS) 1
34 37009 M4 x 20 PAN HEAD SELF TAPPING SCREW 9
35 M37032 M3.5 x 12mm T15 PAN HEAD 1
36 M37003 GRIP 1
37 540962 DECAL KIT - RIGHT, LEFT 1
38 751963 WARNING LABEL 1
39 540964 SPRING LABEL 1
MAINTENANCE
IMPROPERLY MAINTAINED TOOLS CAN CAUSE SERIOUS INJURIES
TO TOOL OPERATOR AND BYSTANDERS –
CLEAN TOOL DAILY
Always make sure the tool is not loaded before performing any service or repair and
always wear approved eye protection when cleaning or servicing the tool.
DAILY CLEANING
All front end parts shown in the disassembly section are to be cleaned daily with a good
detergent oil and wire brush. Remove all dirt and carbon buildup and wipe parts dry with a
clean rag. Check all parts for wear or damage before reassembly and replace or repair any
worn or damaged parts.
PERIODIC COMPLETE CLEANING / GENERAL MAINTENANCE
Heavy or constant exposure to dirt and debris may require that the tool be cleaned
more extensively. Complete disassembly and cleaning of all parts may be necessary to
restore the tool to normal operation. General maintenance should be performed every six
months or more often if the tool is subjected to heavy use. General maintenance/complete
cleaning should be done by a qualified repair person.
ALWAYS FUNCTION TEST THE TOOL AFTER PERFORMING ANY
SERVICE. SEE PAGE 9 FOR DETAILS ON THE FUNCTION TEST.