FUEL CELL AND METERING VALVE
FUEL CELL AND METERING VALVE
10
INSERTING FUEL CELL
With the Metering Valve Stem pointed toward the
front of the tool, insert the Metering Valve/Fuel
Cell Assembly .
As you slide the Metering Valve/Fuel Cell Assembly
into the GypFast tool, you will notice that there is a
Red Adaptor at the top of the Cylinder Pocket . As
is shown in the illustration, this Adaptor is designed
to ensure that the Metering Valve Stem is properly
aligned with the small hole, or orifice that leads to the
Combustion Chamber . Insert the Metering Valve
Stem into the orifice of the red colored Adaptor .
You complete the loading of Fuel Cell in the
GypFast tool by closing the Actuator Cover . You
do this by swinging it up and over the Fuel Valve/
Cylinder Assembly and pushing down until the
Actuator Cover snaps into position .
OUTDOOR WEATHER AND THE
GYPFAST TOOL
Use the GypFast tool outdoors, in clear weather,
when the Tool, Fuel Cell, and Battery are between
20°F (-7°C) and 120°F (49°C) . Colder temperatures
may damage the GypFast Tool and Battery . Hotter
temperatures may damage the Tool and Fuel Cell .
Fuel should be stored out of direct sunlight in
surroundings less than 120°F (49°C) . After extended
periods of continuous use, cool the Tool by running
the Fan Motor .
Operation when the Tool is less than 20°F (-7°C)
may damage the tool . Fuel Cells at cold tempera-
tures lose the required propellant force . Bring
the Tool, Battery, and Fuel Cell above minimum
operating temperature without direct exposure to
flame, and check the Battery .
CAUTION
The GypFast tool should not be used in the
rain or where excessive moisture is present .
These conditions may result in damage to tool
components and cause tool to malfunction .
