RAMMER 455, Original Instructions Manual

Page: 19 / 60

Operation - Page 19 COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
Safety 455
Do not use this product or any of its parts for lifting. See “Lifting instructions” on
page 8. Contact your carrier dealer to find out how to lift with your carrier.
SPARE PARTS
Use only genuine spare parts. Use only genuine tools with hydraulic hammers. The
use of other spare part or hammer tool brands may damage the product.
EQUIPMENT CONDITION
Defective equipment can injure you or others. Do not operate equipment which is
defective or has missing parts.
Make sure the maintenance procedures in this manual are completed before using
the product.
REPAIRS AND MAINTENANCE
Do not try to do repairs or any other maintenance work you do not understand.
MODIFICATIONS AND WELDING
Non-approved modifications can cause injury and damage. Contact your local
dealer for advice before modifying the product. Before welding on the product
while it is installed on the carrier, disconnect the carrier alternator and battery. Note
that welding of the hammer tools will render them useless and make the warranty
void.
METAL SPLINTERS
You can be injured by flying splinters when driving metal pins in and out. Use soft-
faced hammer or drifts to remove and fit metal pins, such as pivot pins. Always wear
safety glasses.
LABELS ON THE PRODUCT
Safety labels communicate the following four things:
■
The severity level of the risk (i.e. signal word "DANGER" or "WARNING").
■
The nature of the hazard (i.e. the type of hazard: high pressure, dust, etc.).
■
The consequence of interaction with the hazard.
■
How to avoid the hazard.
You must ALWAYS follow the instructions of the safety messages and symbols of
the product safety labels and the instructions set forth in the manuals to avoid death
or severe injury!