RAM 2014 RAM PROMASTER, User Manual

Page: 50 / 108

• To drive, start the engine, then move the shift lever from NEUTRAL (N) to the
DRIVE (D) position for automatic mode, the MANUAL (M) position for manual
mode, or the REVERSE (R) position.
• Only shift into DRIVE (D) or REVERSE
(R) when the accelerator pedal is re-
leased and the vehicle is stopped. Be
sure to keep your foot on the brake
pedal when shifting between these
gears.
Instrument Cluster Messages
• Messages will be displayed in the instrument cluster to alert the driver when
certain unusual conditions occur. These messages are described below.
MESSAGE DESCRIPTION
Transmission/
Gearbox Fault (Red)
When the ignition key is turned to ON/RUN/MAR,
the Transmission Fault Indicator light turns on and should go
off after a few seconds.
The Transmission Fault Indicator illuminates either steady or
blinking (together with this message and a buzzer) to indicate
a transmission fault.
Contact your authorized dealer if the message continues
to appear.
Reduce Gear
Changes
This message indicates that the driver is operating the
transmission incorrectly.
Incorrect use (by the driver) could automatically activate a
procedure for protecting the system.
Contact you authorized dealer if the message continues
to appear.
Manual Mode Not
Available
MANUAL (M) mode is not available, due to a fault or other
condition. Use the DRIVE (D) position to operate the vehicle.
Contact your authorized dealer if the message continues to appear.
Automatic Mode Not
Available
Automatic (DRIVE) mode is not available due to a fault or other
condition. Use MANUAL (M) mode to operate the vehicle.
Contact your authorized dealer if the message continues to appear.
DIESEL
48