RAM 2014 RAM PROMASTER, User Manual, Page: 66 / 108

4. There are two jack engagement points on the vehicle for the front and rear tires.
The front tire jacking location is located behind the front tire and in front of the
drivers door. The rear tire jacking location is located in front of the rear tire and
front of the leaf spring mount.
5. Operate the jack using the lug bolt
adapter and wrench handle.
6. Rotate the wheel wrench clockwise to
raise the vehicle until the wheel just
clears the surface.
7. Remove the wheel bolts and pull the
wheel off. Install the spare wheel and
wheel bolts with the cone shaped end
of the wheel bolts toward the wheel.
Lightly tighten the wheel bolts. To
avoid the risk of forcing the vehicle
off the jack, do not fully tighten the
wheel bolts until the vehicle has been
lowered.
8. Using the wheel wrench, finish tight-
ening the wheel bolts using a crisscross pattern. The correct wheel bolt tightness
is 145 ft lbs (197 N·m) torque. If in doubt about the correct tightness, have them
checked with a torque wrench by your authorized dealer or at a service station.
9. Install the wheel center cap and remove the wheel blocks. Do not install chrome or
aluminum wheel center caps on the spare wheel. This may result in cap damage.
10. Lower the jack to its fully closed position.
11. Stow the cable and flat tire before driving vehicle.
12. Stow the jack, jack handle and winch handle tools back in the stowage
compartment.
13. Check the compact spare tire pressure as soon as possible. Correct the tire
pressure as required.
Rear Jacking Location
WHAT TO DO IN EMERGENCIES
64