6 Installation
Instructions on mounting and securing the mounting kit to the enclosure and the bearing pole.
6.1
Mounting
Step 1.
Fix the device bracket on the bottom of the enclosure with four M6*12 screws as shown below.
Step 2.
Position and tighten the pole clamps together around the pole with bolts, washers, and nuts.
Note:
The diameter of the pole that is supported by the brackets is 50-100 mm. If the pole diameter is more than this
value, the steel strips can be used. The standard mounting kit does not include steel strips. If needed, they should be
purchased separately.
Step 3.
Hang up the enclosure and fasten it with two M6*12 screws.
