Documentation Center
Figure 11: Fixing the Charge Module
13. Close the top cover with M4*12 screws. Make sure that the rubber seal is placed correctly in the groove
between the box and the lid to prevent leaks.
Figure 12: Closing the enclosure
Installation
Instructions on mounting and securing the mounting kit to the enclosure and the bearing pole.
1. Fix the included cross bracket on the bottom of the enclosure with four M6*12 bolts.
Figure 13: Mounting the cross bracket
2. Place two pieces of the clamp around the pole and tighten them with the included M6*110 bolts, washers, and
nuts.
