RAK RAK5005-O, Quick Start Manual, Page: 9 / 10

Documentation Center
Figure 21: Applying even forces on the proper location of a WisBlock module to detach the module from the Base Board
Battery Connection
RAK5005-O can be powered via the USB cable or Li-Ion/LiPo battery via the dedicated connectors, as shown in
Figure 22. The matching connector for the battery wires is an
JST PHR-2 2 mm pitch female .
Figure 22: Battery Connection
The battery can be recharged as well via a small Solar Panel, as shown in Figure 22. The matching connector for
the solar panel wires is an
JST ZHR-2 1.5 mm pitch female . The GND pin of Battery Connector is located on
edge of the board.
⚠
WARNING
Only 3.7-4.2 V Rechargeable LiPo batteries are supported. Do not use other types of batteries with the
system.
Make sure the battery wires are matching the polarity on the RAK5005-O board. Not all batteries have
the same wiring.
Solar Panel Connection