Documentation Center
Figure 8: Apply forces to buckle the heard to the socket
5. In the process of buckling and applying force, avoid the application of uneven force on both sides.
Figure 9: Avoid applying uneven forces
6. When the buckling process is completed, check that the header and socket are kept in parallel.
Figure 10: Correct way to buckle the WisConnector’s header to the socket
7. If after buckling, the header and socket are not in a parallel state (not fully assembled in one place), then press
the even force on both sides of the long side to complete the correct buckling.
Figure 11: WisConnector’s header is not parallel to the socket
8. When the aforementioned steps are not completed yet, do not apply force to buckle. Otherwise, there will be a
risk to damage the connector. When the connector cannot be smoothly buckled down, repeat the alignment
step.
Detaching a WisConnector
1. To disconnect the header from the socket, pull-out in parallel with even forces.