Documentation Center
A WisBlock IO module is designed to be installed on the IO slot of the RAK5005-O Base Board. There is a single
IO slot in the RAK5005-O Base Board. As shown in Figure 18, the location is properly marked by silkscreen.
Follow carefully the procedure of the section,
attaching a WisConnector
, to attach a WisBlock Sensor module.
Once attached, fix the module with three pieces of M1.2 x 3mm screws.
Figure 18: WisBlock IO silkscreen on the RAK5005-O Base Board
Disassembling a WisBlock Module
1. The procedure to disassemble any type of WisBlock modules is the same. As shown in Figure 19, first, remove
the screws.
Figure 19: Removing screws from the WisBlock module
2. Once the screws are removed, on the PCB of a WisBlock module, there is a silkscreen that shows the correct
location where force can be applied. By applying even force under the marked area, the module can be
detached from the Base Board. See Figure 20 and Figure 21.
Figure 20: Detaching silkscreen on the WisBlock module