Documentation Center
📝
NOTE:
This guide uses two arrows. Refer to Figure 4 for its representation.
Figure 4: Notation within the guide
1. Align the connectors. Keep the header parallel and place it lightly in the corresponding lap joint of the socket.
Figure 5: Alignment of WisConnector
2. Fit the connector. Tilt one end of the connector (header) less than 20 degrees, while do not apply force during
this process, gently place the other end in parallel.
Figure 6: Fit the WisConnector’s header inside of the socket
3. After the above alignment steps, the header and socket are matched, but still not buckled.
Figure 7: WisConnector’s header matched inside of the socket
4. Apply forces evenly by pressing in parallel, then there will be a sound confirming the completion of the buckling.