RAIS/attika NEXO 100 Classic Gas, Manual

Page: 28 / 88

28
Chimney/Flue
This stove must be either installed with a vertical terminal (C31) or a hor-
izontal terminal (C11) Must only be installed with a flue with a balanced
draught (also known as a concentric draft) as stated by RAIS/attika.
The flues approved by RAIS/attika are approved for use with the stove.
If the stove is installed with flues other than those approved. RAIS/attika
cannot guarantee or accept responsibility for the correct and safe func-
tioning of the stove. and will invalidate the CE mark.
RAIS/attika recommends that the stove be installed with a chimney of
the following make:
On-Top-Metalotherm USD or On-Top-Metalo-
therm US .
Other approved chimney products are: Jeremias , Muelink & Grol , Pou-
joulat PGI .
Joints at vent pipes must be airtight and protected against separation by
using locking bands, or suitable rivets / screws.
If possible a measuring connection piece should be installed on the flue
in the same room as the stove so that a combustion check can be per-
formed. Where the terminal is accessible, this is unnecessary.
Ensure the flue terminal position complies with Building Regulations Ap-
proved Document J, BS EN 5440-1 and the label in these instructions.
Ensure that flue products cannot re-enter the property even if compliant
with the regulations. If the terminal is below 2m above ground level, a
terminal guard must be fitted.
Flue assembly must follow the flue manufacturer’s instructions.
The stove is supplied with smoke connecting pieces prepared for internal
assembly of the outflow pipe. with diameter Ø100/ø150
UK