RainSoft Ultrefiner II, User Manual

Page: 9 / 48

9
4. Install the Faucet
• Select a location for the faucet to be mounted.
• Drill a hole according to the manufacturer’s recommendations.
• Mount the faucet per instructions.
• If using faucet air gap, press drain line tubing onto faucet.
• Use 3/8 inch tubing (not supplied) to connect the faucet to the system
outlet. Make sure the flow restrictor is installed in the 3/8 inch tubing
(not supplied) connected to the outlet of the Ultrefiner II system.
5. Install the Inlet Shut Off Valve (Not Supplied)
• Turn off the cold water supply and open the cold water faucet to relieve
any line pressure;
• Install an inlet shut off valve (not supplied) between the existing shut
off valve and the kitchen faucet, in a way that conforms to state and
local plumbing codes;
• Use 1/4 inch tubing (not supplied) to connect the inlet shut off valve to
the system inlet.
6. Install the Storage Tank
• Select a location for the storage tank. The storage tank can be installed
vertically or horizontally;
• Wrap PTFE Thread Sealant Tape (not supplied) around the threads
of storage tank ;
• Install the shut off valve (supplied) onto the storage tank. The shut off
valve must be in the open position;
• Use the 3/8 inch x 4 foot tubing (supplied) to connect the storage tank
shut off valve to the tank port on the Ultrefiner II Bracket. Additional
tubing may be required pending tank location to location of Ultrefiner-
II Bracket.
Helpful Tip: If the desired installation location is
in the basement, the storage tank can be
mounted in between the floor joists. The closer
the storage tank is to the Ultrefiner II bracket
assembly, the greater the flow of water.
The storage tank can be installed vertically or
horizontally.
!
Important Note: The inlet shut off valve must
have a 1/4 inch tube connection.
PUSH TUBE STRAIGHT PAST PUSH TUBE STRAIGHT PAST
O-RING TILL TUBE STOPS O-RING TILL TUBE STOPS
TUBE CORRECTLY LOCATED TUBE CORRECTLY LOCATED
IN SECURED POSITION IN SECURED POSITION
PUSH IN COLLET TO RELEASE TUBE PUSH IN COLLET TO RELEASE TUBE
A
Helpful Tip: To secure the connection, wet the end
of the tubing and press the tubing firmly into
cartridge.
Figure 8
TUBING CONNECTION PORT TUBE INSERTION DISTANCE(A
)
UF II INLET - 1/4" TUBE 3/4"
UF II DRAIN - 1/4" TUBE 3/4"
UFII TANK - 3/8" TUBE -DOUBLE O-RING 1"
UF II OUTLET - 3/8" TUBE
-
DOUBLE O-RING 15/16"
STORAGE TANK JG - 3/8" TUBE 3/4"
FAUCET FITTING - 3/8" TUBE 3/4"