• If the Water Lines are void of fluid the system will need to be
primed. Priming consists of allowing the Pod to push out any air
in the system until fluid reaches the Pod from the reservoir.
1. On occasion you will need to help the Pod bring the fluid into
the pump. If the Pod needs assistance to pull the fluid to the pump,
perform the following steps.
A. Please disconnect the Water Line where it attaches to the Hub’s
Elbow. Power the system and press the Microbutton. This should
allow fluid to flow more freely through the system and should
remedy the problem.
B. If the problem persists please disconnect the 1/4” Fluid Line from
the output side of the Pod. The left side as you face it, closest to the
“F”. Note that water flows from the “F” of FluidLogic
™
logo toward
the “C” and outward to the user.
C. Bring the hose to your mouth and apply suction to the Line. Once
the fluid has come to the end of the Line attach it back onto the Pod
and run the system to remove any remaining air from the Fluid Lines.
2. If the problem persists please check the Lines to assure that none
of them have become kinked inhibiting the flow of fluid through the
system. If a Line has become kinked you can remedy the problem
with the following steps:
A. Heating the hose a bit with a blow dryer or heat gun on the low
setting and reshape the hose back into the proper shape.
B. Replace the line that has become kinked, assuring that the pathway
allows for proper flow for fluid in the lines. If necessary, re-route the
line to avoid future issues.
TROUBLE SHOOTING
FLUIDLOGIC.COM
Summary of Contents for FLUIDLOGIC
