Page 14 mvEnterprise Release 4.1 on AIX Installation Guide
8. Install the mvEnterprise Release 4.1.
ABS
by typing the command:
./absrestore
This restores the mvEnterprise 4.1
ABS
from the release tape.
Successful completion of an absrestore displays the message:
ABS
tape loaded with XXX frames used.
9. If you wish to use the pickoda monitor program, proceed with the
following steps:
a) Save a copy of the current mvEnterprise monitor program (i.e.,
prodpick
) to a new name. Type:
mv prodpick prodpick.reg
b) Replace the existing mvEnterprise monitor program with the
mvEnterprise/ODA monitor program.
cp -p pickoda prodpick
10. If this is a new installation or you are doing a complete file restore,
proceed with Steps 11-15 to complete the installation procedure.
If this
is
an upgrade, and you are not doing a complete file restore,
perform a
COLDSTART
by typing the command:
./coldstart
Then, proceed with Steps 14-15.
11. If this
is
a new installation, leave the mvEnterprise Release 4.1 tape
inserted.
If this
is not
a new installation, remove the mvEnterprise Release 4.1
release tape and insert the base file-save tape in drive 0.
12. Perform a file restore by typing the command:
./filerestore
The following prompts display:
Do you really wish to file restore prodpick (y/n)?
Type
Y
.
Load Data Tape and press "C"
Type
C
.
