Chapter 4 Configuration Software Instructions
After the software is installed, an "
" icon will be generated on the
desktop, and the software can be opened by double-clicking it.
4.1
Set detection parameters
Connect the device to the computer via a USB data cable, and open the
software to automatically read the device information. After editing the device
parameters, click "Write Device Information" to write the parameters to the device.
It should be noted that after the modified parameters, tick the modified parameters, and
then click Write Device Information, this parameter will be written to the device. This function is
to facilitate the modification of individual parameters when other parameters are modified by
mistake. Set.
Software version:
factory default, can be viewed but not modified.
Battery power:
the current remaining power of the tester.
Number of stored entries:
the number of records currently stored by the detector
(the total number of records for all sensors).
Current time:
You can check the clock time indicated by the detector to determine
whether you need to adjust the time.
Allow recording:
Set the storage function of the detector to be turned on or off.
Recording interval:
Set the recording interval of the detector (default 60 seconds).
Current recording status:
the open status of data recording, closed by default.