12 cm
(4.7 inch)
3.6m/11.8ft
1
1a
1. Place the power supply (transformer) at least 3.6 meters / 11.8 feet from the pool and at
least 12 cm / 4 Inch above the surface (fig.1). The transformer will supply low voltage to
the cleaner.
2. Uncoil the cable.(fig.1a)
unit
Operating the pool cleaner - Quick start guide
4. Plug the cable into the power supply. Depending on your model (Type I or Type II),
make sure the key on the plug corresponds exactly with the key slot on the socket of
the power supply (fig.3a). (See details on the next page)
5. Plug the power supply into a grounded outlet. Ensure that the electric outlet has been
properly grounded (fig.3b).
6. Press the “ON” button on the power supply (fig 4). The light will glow indicating that the
system is “ ON “ and the pool cleaner will start the cleaning cycle. The unit keeps
record of the number of cleaning cycles. Only an authorized service center can
display the accumulated cleaning cycles.
3. Place the unit in the water.
Turn the unit side to side in
the water to allow air to
escape from the body and
then let the cleaner sink to the
bottom of the pool (fig.3).
Then, spread the cable over
the surface of the pool as
evenly as possible (fig.1).
3
3a
3
3b
Type I
Type II
4
