Barriers should be located so as to prohibit permanent structures,
equipment or similar objects from being used to climb the barriers.
PREPARATION
Installation of small swimming pool usually takes only 10 minutes with
1 people.
Recommendations regarding placement of the pool:
Do not install the pool on a slope or inclined surfaces, on soft or loose
soil conditions (such as sand or mud), or on an elevated surface such
as a deck, platform or balcony, which may collapse under the weight of
the filled pool.
• It is essential the pool is set up on solid, level ground. If the pool is
set up on uneven ground it can cause collapse of the pool and
flooding, causing serious personal injury and/or damage to personal
property.
• Do not set up on driveways, decks, platforms, gravel or asphalt.
Ground should be firm enough to withstand the pressure of the
water; mud, sand, soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones
and twigs.
• Check with your local city council for by-laws relating to fencing,
barriers, lighting and safety requirements and ensure you comply
with all laws.
INSTALLATION
Assembly can be completed without tools.
NOTE:
It is important to assemble pool in the order shown below. Adult
assembly required.
1. Find solid, level ground and clear it of debris.
ATTENTION:
Do not set up the pool under cables or under trees.
2. Spread out the pool and make sure it is right side up.
3. Cover the water valve.
4. Inflate the top ring and close the air valve after inflation.
NOTE:
Do not over inflate. Over inflation may cause damage.
5. Put 1in. to 2in. (2.5cm to 5cm) of water in the pool to cover the floor.
Once pool floor is slightly covered, gently smooth out all wrinkles.
Start in the center of the pool and work your way clockwise to the
outside.
6. Fill the water until the wall is straight up, and the water reaches the
welding line. Please kindly pay the utmost attention not over fill the
pool for security reasons.
1
Item
57392E
Dimension
6 ft. x 20 in.
FAST SET POOL
OWNER’S MANUAL
Read and Follow All Safety Information and
Instructions.
Keep for future reference.
Failure to follow these warnings and instructions
can result in serious injury or death to users,
especially children.
Prevent Young Children From Drowning:
Install fencing or approved barrier around all sides of pool.
State or local laws or codes may require fencing or other approved
barriers.
Check state or local laws and codes before setting up pool.
Drowning occurs silently and quickly. Assign an adult to supervise pool
and wear provided water watcher tag.
Keep children in your direct sight when they are in or near pool and
when you are filling and emptying pool.
When searching for a missing child, check pool first, even if you think
your child is in the house.
Pool presents a drowning hazard even during filling and draining of the
pool. Maintain constant supervision of children and do not remove any
safety barriers until the pool is completely empty and stowed away.
Refer to the list of barrier recommendations and guidelines as
described in CPSC Publication No.362.
Assign an adult to be responsible for watching children in the pool.
Give this person a “water watcher” tag and ask that they wear it the
entire time they are in charge of supervising children in the pool. If they
need to leave for any reason, ask this person to pass the “water
watcher” tag and the supervision responsibility to another adult.
Prevent Young Children From Gaining Access to Pool:
Remove pool ladders before leaving pool. Toddlers can climb ladder
and get into pool.
Position furniture away from pool so that children cannot climb and
gain access to pool.
When leaving pool, remove floats and toys from pool that might attract
a child.
Be Prepared to Respond to an Emergency:
Keep a working phone and list of emergency numbers near pool.
Become certified in cardiopulmonary resuscitation (CPR) so you can
respond to an emergency.
Diving Risk:
Do not dive into the pool. Diving into shallow water can result in a
broken neck, paralysis, or death.
Electrocution Risk:
Keep all electrical lines, radios, speakers and other electrical
appliances away from the pool.
Do not place pool near or under overhead electrical lines.
Safety Barrier Guidelines for Residential Swimming Pool
Section I:
Outdoor swimming pool
An outdoor swimming pool, including an inground, aboveground, or
onground pool, hot tub, or spa, should be provided with a barrier which
complies with the following:
1. The top of the barrier should be at least 48 inches above grade
measured on the side of the barrier which faces away from the
swimming pool. The maximum vertical clearance between grade
and the bottom of the barrier should be 4 inches measured on the
side of the barrier which faces away from the swimming pool.
Where the top of the pool structure is above grade, such as an
aboveground pool, the barrier may be at ground level, such as the
pool structure, or mounted on top of the pool structure. Where the
barrier is mounted on top of the pool structure, the maximum
vertical clearance between the top of the pool structure and the
bottom of the barrier should be 4 inches.
2. Openings in the barrier should not allow passage of a 4-inch
diameter sphere.
3. Solid barriers, which do not have openings, such as a masonry or
stone wall, should not contain indentations or protrusions except
for normal construction tolerances and tooled masonry joints.
4. Where the barrier is composed of horizontal and vertical members
and the distance between the tops of the horizontal members is
less than 45 inches, the horizontal members should be located on
the swimming pool side of the fence. Spacing between vertical
members should not exceed 1-3/4 inches in width. Where there are
decorative cutouts, spacing within the cutouts should not exceed
1-3/4 inches in width.
5. Where the barrier is composed of horizontal and vertical members
and the distance between the tops of the horizontal members is 45
inches or more, spacing between vertical members should not
exceed 4 inches. Where there are decorative cutouts, spacing
within the cutouts should not exceed 1-3/4 inches in width.
6. Maximum mesh size for chain link fences should not exceed 1-3/4
inch square unless the fence is provided with slats fastened at the
top or the bottom which reduce the openings to no more than 1-3/4
inches.
7. Where the barrier is composed of diagonal members, such as a
lattice fence, the maximum opening formed by the diagonal
members should be no more than 1-3/4 inches.
8. Access gates to the pool should comply with Section I, Paragraphs
1 through 7,and should be equipped to accommodate alocking
device. Pedestrian access gates should open outward, away from
the pool, and should be self-closing and have a self-latching
device. Gates other than pedestrian access gates should have a
self-latching device. Where the release mechanism of the
self-latching device is located less than 54 inches from the bottom
of the gate, (a) the release mechanism should be located on the
pool side of the gate at least 3 inches below the top of the gate and
(b) the gate and barrier should have no opening greater than 1/2
inch within18 inches of the release mechanism.
9. Where a wall of a dwelling serves aspart of the barrier, one of the
following should apply:
(a) All doors with direct access to the pool through that wall should
be equipped with an alarm which produces an audible warning
when the door and its screen, if present, are opened. The alarm
should sound continuously for a minimum of 30 seconds within
7 seconds after the door is opened. Alarms should meet the
requirements of UL2017 General-Purpose Signaling Devices
and Systems, Section 77. The alarm should have a minimum
sound pressure rating of 85 dBA at 10 feet and the sound of the
alarm should be distinctive from other household sounds, such
as smoke alarms, telephones, and door bells. The alarm should
automatically reset under all conditions. The alarm should be
equipped with manual means, such as touchpads or switches,
to temporarily deactivate the alarm for a single opening of the
door from either direction. Such deactivation should last for
nomore than 15 seconds. The deactivation touchpads or
switches should be located at least 54 inches above the
threshold of the door.
(b) The pool should be equipped with a power safety cover which
complies with ASTM F1346-91 listed below.
(c) Other means of protection, such as self-closing doors with
self-latching devices, are acceptable so long as the degree of
protection afforded is not less than the protection afforded by
(a) or (b) described above.
10. Where an aboveground pool structure is used as a barrier or where
the barrier is mounted on top of the pool structure, and the means
of access is a ladder or steps, then (a) the ladder to the pool or
steps should be capable of being secured, locked or removed to
prevent access, or (b) the ladder or steps should be surrounded by
a barrier which meets Section I, Paragraphs 1 through 9. When the
ladder or steps are secured, locked, or removed,any opening
created should not allow the passage of a 4-inch diameter sphere.
Section II:
Barrier Locations
Refer to the item name or number stated on the packaging.
Packaging must be read carefully and kept for future reference.
Prevent Drowning
WARNING
Children under 5,
especially toddlers are at
highest risk of drowning.
Closely watch children
who are
in or near
this
pool. Empty pool or
prevent access when not
in use.
WARNING
You can break your
neck and be
paralyzed!
No Diving
Keep all electrical lines,
radios, speakers, and
other electrical devices
away from pool.
Do not place pool near
or under overhead
electrical lines.
Electrocution Risk
WARNING
DISMANTLING THE POOL
1. Open water valve on the bottom of the pool, water will drain
automatically. (Check local regulations for drainage by-laws). Then
push down the wall of the pool to release the water. Make sure
release all the water in 20 minutes.
NOTE:
Drain by adult only!
2. Open the air valve on the top ring to deflate.
3. Air dry.
ATTENTION:
Do not leave the drained pool outside.
REPAIR
If your pool is damaged, use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
POOL MAINTENANCE
WARNING:
If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of your children.
1. Change the water of pools frequently (particularly in hot weather) or
when noticeably contaminated, unclean water is harmful to the user’s
health.
2. Please contact your local retailer to obtain chemicals to treat the
water in your pool. Be sure to follow the chemical manufacturer’s
instructions.
3. Proper maintenance can maximize the life of your pool.
4. See packaging for water capacity.
CLEANING AND STORAGE
1. After deflation, use a damp cloth to gently clean all surfaces.
NOTE:
Never use solvents or other chemicals that may damage the
product.
2. Remove all the accessories and spare parts of the pool and store
them clean and dry.
3. Once pool is completely dry, sprinkle with talcum powder to prevent
pool from sticking together, fold pool carefully. If pool is not
completely dry, mould may result and will damage the pool liner.
4. Store liner and accessories in a cool, dry place out of children’s
reach, with a moderate temperature between 5°C / 41°F and 38°C /
100°F.
5. During the rainy season, pool and accessories should be stored as
instructed above.
6. Unproper draining of the pool might cause serious personal injury
and/or damage to personal property.
7. Check the product for damage at the beginning of each season and
at regular intervals when in use.
