english
27
TBOS
™
Field Transmitter
english
26
Possible cause: The microprocessor did not reset
properly.
Solution:
Remove the battery. Short the TBOS
Field Transmitter battery clip (not
the battery) contacts together with a
paper clip or other piece of metal
for 30 seconds. Reinstall a fresh bat-
tery.
Problem:
Even, Odd and 1 through 6 day
cycles do not appear on the TBOS
Field Transmitter
Possible cause: The TBOS field transmitter is in
Standard mode.
Solution:
Switch to Turbo mode by pressing
the
B
and
P
keys simultaneously.
Problem:
The Control Module will not
accept Even, Odd or 1 through 6
day cycles from the TBOS Field
Transmitter
Possible cause: The Control Module is not a TBOS
Control Module. UNIK Control
Modules will not accept these cycles
Solution:
Replace the UNIK Control Module
with a TBOS Control Module, or
program a standard (seven day)
cycle.
WARNING:
This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses and can radi-
ate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause interference to radio
communications. However, there is no guar-
antee that interference will not occur in a par-
ticular installation.
If the equipment does cause harmful interfer-
ence to radio or television reception, which
can be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one of the follow-
ing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications not expressly
approved by Rain Bird Sales, Inc. could void
the user’s authority to operate the equipment.
This product was FCC certified under test
conditions that included the use of shielded
I/O cables and connectors between system
components. To be in compliance with FCC
regulations, the user must use shielded cables
and connectors and install them properly.
