Discs Removal
9.1 Inspection of the Filters
Clean the discs using clean water. or
an
acid
solution
if
you
cannot
remove the dirt from the discs. In
which case you should follow the
protection measures according to
the Safety Sheet regarding
the acid to use.
•
Do not mix discs from different filters
to avoid changes in the number of
discs per filtering element.
•
Placing the filtering element
improperly can cause breakage.
•
Check the chemical compatibility
between the lubricant used in the
base of the filtering element and
the materials of the filter.
15
•
Pressure Equipment:
•
Be sure the filter is depressurized before opening it.
•
If necessary, clean only the discs in an acid solution.
•
If an acid solution is used to clean the discs, use the
adequate protection (clothes, glasses, gloves, face shield
...) Consult the Safety Sheet of the product used.
•
Do not contact any part of the filter with the acid solution
except for the discs
9.2 Manual clean of the Discs
1.Open the clamp and take away the lid
2.Remove the filtering element carefully.
3.Turn the piston until it is released; take away the piston.
4.Take away the discs
5.To assemble the filtering element proceed the other way round.
6.
Place all the discs
7.Thread the piston making a soft pressure at the same time it is turned to its adjustment.
8.Lubricate the base o-ring of the filtering element, with neutral petroleum jelly if possible.
9.Place the filtering element pushing carefully downwards
10.Close the filter.
Discs Installation
Summary of Contents for HDF 1X2
Page 1: ...1X2...
