Rain Bird ESP-LXME, Installation, Programming & Operation Manual, Page: 108 / 116

102 ESP-LXME Controller
Install Modules
Install BM-LXME Base Module
Install the BM-LXME Base Module in Slot 0.
b b
NOTE: If your ESP-LXME controller included an FSM-LXME Flow
Smart Module, see Section E for installation procedures.
BM-LXME Base Module
b d
CAUTION:
Be careful not to bend the pins in the sockets when
installing the module.
b b
NOTE: The Base and Flow Smart Module include a jumper wire
connecting the weather sensor (SEN) terminals. Do not remove
the jumper wire unless you install a weather sensor.
A
Orient the connector on the bottom of the module with the
connection socket in Slot 0 on the controller backplane.
1
B
Carefully fasten the module onto the controller backplane,
pressing firmly until it snaps into place. The red light on the module
will flash on and off once if the module is installed correctly. If the
light does not flash once, verify the module is seated correctly.
2
b b
NOTE:
To remove the module, press in on the (two) release
buttons on either side of the module.