12
www.raider.bg
It must be done to change the direction of rotation when the spindle rotates a drill!
5.3.1. When you need to vent large diameter, is recommended first to break a small opening, which will then
be drilling to the desired size. This will prevent overloading the drill. Drilling deep holes should be done gradually, as
periodically removed from the drill hole to remove chips or dust. If during drilling to drill block up in holes, you should
exclude drill. Use a change of direction of rotation to remove the drill from the hole. Drill must be kept in alignment
with the hole. Ideally, the drill should be placed perpendicular to the surface of the material being processed. If the
condition for perpendicularity is not respected at work can lead to trapped or breakage in drill hole and injury to the
user.
5.4. Mode “Chiselling”
Press the release button and turn the switch operating modes into position
Make periodic breaks at work.
Keep and refer to the accessories carefully.
Do not throw the tool, do not overload, do not soak in water and other liquids do not use it for mixing adhesives
and concrete coatings.
6. Service and support.
6.1. Striking drill does not require additional lubrication or special maintenance. There are no parts requiring
maintenance by the user. Never use water or any liquid chemical cleaning drill. It should only be wiped with a piece
of dry tissue. Should always be stored in a dry place and ventilation holes in the body of the drill to be free.
6.2. Replacing carbon brushes. Worn-out (shorter than 5 mm), up or broken engine carbon brushes should be
replaced. Always replace both brushes simultaneously. Work on replacement of carbon brushes entrusted only to
qualified person with original spare parts in service of business RAIDER.
6.3. The repair of your power is best carried out only by qualified specialists in workshops RAIDER, which used
only original spare parts. Thus ensuring their safe operation
6.4. Approximately 60 hours of work (about 5,000 drilled holes) should be completed with 8-10 grams of
grease. Opening the grease cap 4. Place lithium grease with viscosity 2NLGI / National lubricating greace institute /
For prolonged storage of the breaker, grease should be checked and, if oxidised, changed.
7. Environmental protection.
In view of environmental power tools, additional accessories and packaging must be subjected to
appropriate processing for reuse of the information contained in these materials.
Do not dispose of household waste power tools! Under the EU Directive
2012/19/EC
on scrapped
electrical and electronic equipment and promoting law and national power tools, which can not be used more,
must be collected separately and be subjected to appropriate processing for recovery of contained therein scrap.
Summary of Contents for RDI-HD49
Page 74: ...74 www raider bg EXPLODED VIEW OF RDI HD49 ...
Page 89: ...89 ...
Page 94: ...94 www raider bg ...
Page 95: ...95 ...
