13
The saw blade on the machine can be tilted
by up to 45°.
To do this, proceed as follows:
• Undo the two locking buttons (A).
• Tilt the saw blade to the required angle.
• The angle can be read off on the gauge (B).
• Re-tighten the locking buttons (A).
6. STARTING UP THE CIRCULAR SAW
TABLE
• The machine is switched off by pressing the
red button.
• The machine is switched on by pressing the
green button.
If the mains voltage is interrupted or the mains
plug is taken out of the wall socket, the machine
will immediately be switched off by the safety
switch. If the mains voltage then suddenly comes
back on, the sawing machine will not be switched
on. It will only be switched on again when the
green button is pressed.
7. DUST EXTRACTOR
The saw bench has a connector for a dust
extractor.
Connecting a dust extractor hose with an
inside diameter of 31 mm to this connector gives
you a perfect dust extraction system while sawing.
8. USING THE MACHINE
SAWING
Fig. 5
Take care that your hands do not get too close
to the saw blade during sawing.
To saw, proceed as follows:
• Undo the two screws in the rip fence (A) at
the side of the table.
• Set the rip fence to the size you require.
• Re-tighten the screws.
• Set the saw guard (C) to the correct height.
• Switch the machine on.
• Press the work slowly and with the minimum
of pressure against the saw blade.
• When the end of the work approaches the
saw blade, use a push stick (B) to feed the work
further.
Use the push stick from the start when feeding
short workpieces.
• Switch the machine off.
RIP FENCE
Fig. 6
The rip fence (B) allows a mitre of up to 45°
to be sawn.
To do this, use the protractor gauge (A), which
moves past the rip fence.
9. Maintenance and repair
In order to maintain the blade in constant repair
and technical readiness work, the following
technical month service should be carried out -
ETO. ETO - every shift Maintenance includes:
• External examination;
• Check the electrical cords, plugs and grounding;
• Check the presence of guard.
• Cleaning (rubbing) the machine.
Repairs saws must be made by specialized
persons.
10. Rules of storage
Storage the machine should be at a temperature
of plus 40 ° C to minus 50 ° C with relative
humidity less than 80% (at a temperature of
20 ° C). Under longtime storage at subzero
temperatures, connecting to the machine to get
to warm, when you use.
In case the machine is being stored for a long
time it is necessary to thoroughly clean the
corroded parts of the machine and coat them with
conservation lubrication of К-17 GOST 10877-76
or other similar lubrication.
11.
ENVIRONMENTAL
PROTECTION.
The machine should be operated
with an external exhaust ventilation
or external dust extraction unit.
The aluminum and plastics parts are
labeled, which allows them to sort and recycle.
In view of environmental power tools, additional
accessories and packaging must be subjected
to appropriate processing for reuse of the
information contained in these materials.
Do not dispose of household waste power tools!
Under the EU Directive 2012/19/EC on scrapped
electrical and electronic equipment and promoting
law and national power tools, which can not be
used more, must be collected separately and be
subjected to appropriate processing for recovery
of contained therein scrap.
Summary of Contents for RD-TS20
Page 43: ...43 Exploded view of Table Saw RD TS20 ...
Page 60: ...60 www raider bg ...
Page 63: ...63 ...