Raider RD-ST02, User Manual

Page: 19 / 110

19
and placing of engine shut down device.
•Dangers caused by defect of machine control system, relate to solidity of the handle, placing of drivers
and marking.
•Dangers caused by tearing (of the chain) during running.
•Dangers caused by shooting up of subjects or splashing of liquids.
ASSEMBLY
1.Align the holes on the upper handle with the holes on the middle handle (fig. 3). Insert the bolts, and use
the lock knobs to tighten them, do not forget the washer (fig. 4).
2.Align the holes on the middle handle and the lower handle. Insert the bolts, and tighten them using the
lock knobs provided,the washer (fig. 5A).
3.Align the holes on the upper tubing of the direction direction control handle with the holes on the lower
tubing. Insert the screw and tighten them using the nut (fig. 6A).
ELECTRICAL REQUIREMENTS
•Connect the device only on the plug with a protective device to prevent stray current (Fl switch) with a
rated fault current of not more than 30 mA.
•Use only one extension cord. Make sure extension cord is the right size or rating for the tool
you’re using. Limit length to 40 m or less. Only use a cord of 1 mm2 guage or larger diameter.
•Cable drum before using completely unwind. Make sure the cord is not damaged.
Caution! Do not touch the damaged cable and pull the mains plug when the cable is damaged while
working. Damaged cables increase the risk of an electric shock. If the power supply is damaged, it
must be immediately replaced with a cable without defect, to avoid dangerous situations.
A Note: In case of doubt, check with your electricity supplier or with your electrician if your home
connection meets these requirements.
•Place the power cord so that it will not interfere with work and to avoid damage.
•Keep cord from heat, corrosive liquids and sharp edges.
•Use only rubber extension cords designed for outdoor use with sufficient cross-section of conductors.
•When disconnecting the power plug do not pull the cord.
•If the service cabel is damaged, let it have changed in accredited service to prevent the danger
•Do not carry or manipulate the machine by service cabel, do not pull up the socket inlet from the socket
outlet by pulling the service cabel. Protect the service cable against heat, grease and sharp edges.
OPERATION
ADJUSTMENT OF DISCHARGE
WARNING: Never direct the snow discharge at the operator, at bystanders, at vehicles or at nearby
windows. The discharged snow and foreign objects accidentally picked up by the snow thrower can
cause serious damage and personal injury. Always orient the dischargein the opposite direction
from where you, bystanders, surrounding vehicles, or windows are located.
Throwing vanes can be adjusted by simply turning of the crank (fig. 7A). Turn the crank clockwise for
throwing left, counterclockwise for thowing right.
SWITCHING ON AND OFF
WARNING! While cleaning, repairs, adjusting, servicing and when you leave the machine always
switch off the motor and unplug the power cord.
1.Before removing it is necessary the engine to be adapted to the outside temperature.
2.Pull the extension cable through the cable grip (fig. 8A)
3.Insert the extension cable coupling into the mains.
4.Turn adjustment bar to bring the discharge in the desired direction.