Raider RD-GLM09, User Manual

Page: 27 / 112

27
NOTE: For rough or uneven lawns, move the height adjustment lever to a higher position. This
will help stop scalping.
SECTION 6: OPERATION
WARNING: Keep hands and feet away from the chute area on the cutting deck. See the eyes,
which can result in severe eye damage.Always wear safety glasses or eye shields.
NOTE: For best results raise the cutting position until it is determined which height is best for
your lawn. See CUTTING HEIGHT ADJUSTMENT LEVER in the CONTROLS section.
GAS AND OIL FILL-UP
Service the engine with gasoline and oil as instructed in the separate engine manual. Read all
instruction carefully.
WARNING: Never fill fuel tank indoors with engine running or until the engine has been allowed to
cool for at least two minutes after running.
EACH TIME YOU START YOUR MOWER ALL UNITS:
Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark plug wire
is fastened securely over the metal tip on the spark plug.
TO START ENGINE AND ENGAGE BLADE
Move the throttle control on the engine to the fast (rabbit) position.
Prime engine as instructed in the separate engine manual.
Stand behind the unit, squeeze the blade control handle and hold it against the
upper handle
NOTE: If any problems are encountered, refer to the TROUBLE SHOOTING section of this manual.
TO STOP ENGINE AND BLADE
Release the blade control handle to stop the engine and the blade
OPERATION ILLUSTRATION FOR THE SELF-PROPELLED MOWER
If the mower is the self-propelled, please pay more attention to the points as follows. Before
starting.please check whether there is any intertwist around the transmission belt or not.
Please tidy up the mower, especial on the belt and it’s wheels.
Should leave the mower untouched for a long time, please check the lubricate
in the gear-box or not.
OPERATION
1 .Before starting, please put the height-adjustor at the lowest grade.
2. Before starting, please keep the throttle cable assy at the middle speed.
3. Collect the BLADE CONTROL LEVER (see Figure 7) braking the engine together with the
upper handle and then start the engine.
4. Collect CLUTCH CONTROL LEVER (see Figure 7) controlling the clutch together with the
upper handle and then start the engine.
5,Should change the moving direction, please release the CLUTCH CONTROL LEVER (see
Figure7), and then turn.
6.When the collector is full.please release the CLUTCH CONTROL LEVER and then release the