21
D. If the motor shaft is bent (do not align!).
E. If a short circuit occurs when the cable is connected.
F. When unsure or problems are not described here.
8. STORAGE
• Keep the machine away from children.
• Turn off the engine and unplug if the machine is not in use.
• Allow the machine to cool before storage.
• Do not store the machine in direct sunlight for long periods.
• Replace worn or damaged safety parts.
• Keep the machine in a clean, dry, dark and freezing place, protected from dust and water and
out of the reach of children. The ideal storage temperature is between 5 and 30 ° C.
• Use the original packaging for storage whenever possible.
• Cover the appliance with a suitable protective coating that does not retain moisture. Do
not use sheet plastic as a protective cover. The non-porous shell will trap moisture around the
machine, promoting rust and corrosion.
9. TRANSPORT
When moving the machine, the drum must be switched off and the aeration base raised as high
as possible.
• Turn off the engine and unplug. When transporting, be careful not to drop or otherwise hit
the machine. When transporting, the machine must be secured against sliding and rolling. Do not
place objects on the device.
• The drum may be damaged during transportation, for example on a hard surface, even when
the engine is switched off.
Therefore, set the working depth of the drum to the highest position during transport.
10. FAULTS AND WAYS TO CORRECT THEM.
The table below shows symptoms of faults and how you can help yourself if your aerator stops
working properly. If you cannot find and correct the problem by following the instructions in the
table, contact a Raider Authorized Repairer. Attention! Before you start troubleshooting, stop the
aerator and unplug the aerator.
Faults
Reasons
Removal
The engine
does not start
No electricity
Check the connection to the network
Defective cable
Check the cable, plug it in, replace it if
necessary, or have it repaired by a qualified
person
Defective fuse/plug combination Prepare for repair at an authorized workshop
Drum is blocked
Remove clogging
Abnormal
sounds
Drum is blocked
Remove clogging
Loosened screws, nuts
or other fasteners
elements
Contact after sales service
Loosened screws, nuts
or other fasteners
elements
Extraordinary
vibrations
The cutting blades are
damaged or dull
Replace with new ones
Working depth is too large
Set a lower working depth
The lawn is too tall
Mowing the lawn before aeration
