Raider RD-CM08, User Manual

Page: 14 / 70

14 www.raider.bg
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test given in EN 61029 and may be used to compare one tool
with another. It may be used for a preliminary assessment of exposure. The declared vibration
emission level represents the main applications of the tool. However if the tool is used for
different applications, with different accessories or poorly maintained, the vibration emission
may differ. This may significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the times
when the tool is switched off or when it is running but not actually doing the job. This may
significantly reduce the exposure level over the total working period.
4. Assembly.
Avoid unintentional starting of the machine. During assembly and for all work on the
machine, the power plug must not be connected to the mains supply.
Delivery Scope. Carefully remove all parts included in the delivery from their packaging.
Remove all packaging material from the machine and the accessories provided.
4.1. Stationary or Flexible Mounting.
To ensure safe handling, the machine must be mounted on a level and stable surface (e. g.,
workbench) prior to using.
4.1.1. Mounting to a Working Surface.
Fasten the power tool with suitable screw fasteners to the working surface. The holes on
the basic framework serve for this purpose.
4.1.2. Flexible Mounting.
In the exceptional case that it should not be possible to firmly bench-mount the power tool,
you can provisionally place the legs of base plate on a suitable surface (e. g. a workbench,
level floor, etc.) without bolting the machine down.
5. Dust/Chip Extraction.
Dusts from materials such as lead-containing coatings, some wood types, minerals and
metal can be harmful to one’s health. Touching or breathing-in the dusts can cause allergic
reactions and/or lead to respiratory infections of the user or bystanders. Certain dusts, such
as oak or beech dust, are considered as carcinogenic, especially in connection with wood-
treatment additives (chromate, wood preservative). Materials containing asbestos may only
be worked by specialists.
Use dust extraction whenever possible.
Provide for good ventilation of the working place.
It is recommended to wear a filter-respirator.
6. Clamping the Work piece.
To ensure optimum working safety, the work piece must always be firmly clamped. Do not
saw work pieces that are too small to clamp. Long work pieces must be underlain or supported
at their free end.
Place the work piece against the angle stop.
Slide the clamping spindle against the workpiece and firmly clamp the workpiece with the
spindle handle.
Loosening the Workpiece.
Loosen the spindle handle.
7. Starting Operation.
7.1. Check the cutting disc before using. The cutting disc must be properly mounted and
must rotate freely. Carry out a 30 second test run with no load. Do not use damaged, out-of-
centre or vibrating cutting discs. Damaged cutting discs can burst and cause injuries.
7.2. User Position.
Do not stand in a line with the cutting disc in front of the machine. Always stand aside of
the cutting disc. This measure provides for better protection of your body against possible
splinters in case of cutting disc breakage.
7.3. Switching On and Off.
To start the machine, firstly press the lock off button. Then press the On/Off switch and
keep it pressed. Note: For safety reasons, the On/Off switch cannot be locked; it must remain