Raider Pro RDP-WP27, User Manual

Page: 30 / 62

www.raider.bg
30
Make sure that the socket-outlet is suf-
ficiently fused (at least 6 A) and in good
working order. Insert the power plug in the
socket-outlet and the equipment is ready for
operation.
Important!
To rule out danger, this work must be left
strictly to a specialist electrician or Cus-
tomer Service.
Operation
You can put the equipment into operation
after you have thoroughly read the installa-
tion and operating instructions. Pay atten-
tion to the following points:
Make sure that the equipment is set up
securely.
Check that the discharge line is fitted cor-
rectly.
Make sure that the electrical connection is
230 V~50 Hz.
Check that the electrical socket-outlet is in
good working order.
Make sure that no moisture or water can
ever reach the power connection.
Make sure that the equipment does not run
dry.
Setting the ON/OFF switching point:
The ON/OFF switching point of the float-
ing switch can be adjusted by shifting the
floating switch in the floating switch notched
holder (Fig. 2/Item 5).
Check the following points before putting
the equipment into operation:
The floating switch must be fitted so that
the switching point height: ON and the
switch point height: OFF can be reached
easily and with little force. Check this by
placing the equipment in a container filled
with water and carefully raising and lower-
ing the floating switch with your hand.
You can then see whether the equipment
switches on and off.
Make sure that the distance between the
floating switch head and the cable holder is
not too small.
If the distance is too small, there is no guar-
antee that the equipment will work correctly.
When adjusting the floating switch, make
sure that the floating switch does not
touch the bottom before the equipment is
switched off.
Important!
Risk of dry running.
Replacing the power cable
If the power cable for this equipment is
damaged, it must be replaced by the manu-
facturer or its aftersales service or similarly
trained personnel to avoid danger.
Cleaning, maintenance and ordering of
spare part s
Important!
Unplug the power plug prior to any mainte-
nance work.
For mobile applications, the equipment
should be cleaned with clear water after
every usage.
For stationary installation, it is recommend-
ed that you check the floating switch for
proper functioning every three months.
Use a water jet to remove any lint or
fibrous particles that may have become
trapped in the housing.
Remove sludge from the shaft bottom and
clean the shaft walls every 3 months.
Use clear water to remove deposits from
the floating switch.
Cleaning the paddle wheel
If a lot of deposits collect in the housing,
the bottom part of the equipment must be
dismantled as follows:
1. Disconnect the intake cage from the
housing.
2. Clean the paddle wheel with clear water.
Important! Do not put down or rest the
equipment on the paddle wheel!
3. Assemble in reverse order.
Maintenance
There are no parts inside the equipment
which require additional maintenance.
Ordering replacement parts: