Raider Pro RDP-SCG20 solo, Original Instruction Manual

Page: 17 / 66

17
wear eye protection when using the silicone /
glue gun.
• Always work in a properly ventilated area
and wear appropriate respiratory protection if
necessary. Vapors from some silicones and
adhesives can be harmful.
• Turn off the device and remove the battery
before inserting or removing an accessory,
before repairing or performing repairs. Unwanted
operation of the tool can cause injuries.
• Use only accessories recommended by the
manufacturer with your model. Accessories that
may be suitable for one tool may create a risk
of injury when used with another tool. Using
inappropriate accessories can cause a risk of
injury.
• Make sure that silicones or adhesives do not
fall on the contact points of the battery. in the
equipment /
• Always read and follow the manufacturer’s
instructions for all types of silicone or adhesive.
Failure to do so may result in personal injury.
• Do not use for cooking.
• Do not use frozen or dried adhesive or sealant
mixtures.
• Do not overload the motor! In case of overload,
switch off the machine, remove the battery,
determine the cause and remove it.
• Follow the installation instructions. The
holder, pipe and threaded ring must be properly
mounted and tightly screwed.
• Always wear safety goggles.
• Danger of pinching! Do not grab the gear bar!
Be careful not to pinch anything from the gear
bar!
• Observe the regulations applicable to your
country for the materials used.
Follow the recommendations of the sealing
compound manufacturers! Please note the
safety data sheet of the material used.
• Adhesives and sealants can cause hazards.
Follow any instructions on the packaging or
information provided by the manufacturer. Do
not use mixtures whose dangers are unknown.
• Do not use solvents, acids or other aggressive
cleaning agents when cleaning.
• Leave the appliance and its parts in a safe
place (eg secure the dismantled pipe against
overturning).
• Only pull the sprocket when the trigger is
depressed.
ADDITIONAL RISKS
• Despite the application of the relevant safety
regulations and the application of protective
equipment, there are risks that cannot be
avoided. These are:
• Hearing impairment.
• Risk of injury due to flying particles.
• Risk of burns due to heating of the accessories
during operation.
• Risk of injury due to prolonged use.
INTENDED USE
The appliance is designed to expel sealing or
adhesive mixtures from cartridges.
This cordless glue gun is designed for
professional application of silicone and glue. Do
not use in wet conditions or in flammable liquids
or gases.
The appliance is not intended for food or medical
/ veterinary purposes. Do not work with pressure
cartridges. Do not use it as a lifting or stretching
device.
The user is fully responsible for all damages
caused by improper use.
Generally accepted accident prevention rules
and attached safety information must be
observed.
ON/OFF
1. Trigger switch 2. Trigger-lock button
To prevent accidental depressing of the switch
trigger (1), a trigger lock button is provided. (2)
To start the tool, press the trigger lock button on
side A and pull the switch trigger. The speed of
the tool is increased by increasing the pressure
on the trigger of the switch. Release the switch
trigger to stop.
After use, press the trigger lock button on side B.
SPEED ADJUSTING DIAL