Raider 031302, User Manual

Page: 13 / 104

13
You can also charge the battery through the modular charging port . The input is a maximum
of 13v at 1.5 mA. This will take approximately 1.5 hours at maximum input. This adapter is not
included.
5. Operating the tool
To activate the tool, press the Trigger (6) and keep it pressed. To switch off the machine,
release the trigger. The trigger is variable speed and the speed depends on the amount of
pressure you apply to the trigger. Light pressure on the trigger results in a low rotational speed.
Further pressure on the switch results in an increase in speed.
5.1. Forward (clockwise) operation:
The motor has an electronic clutch with three different forward speed settings: 1, 2, and 3 (low,
medium and high). The speed setting is adjusted by pushing the ″S″ button on the Electronic
clutch control panel (5) on the base of the tool. If the trigger is momentarily pushed the Electronic
Clutch will be activated.
If one green LED is illuminated, the motor is set to Speed 1. If two green LEDs are illuminated
then the motor is set to speed 2 and three green LEDs for speed 3. Push the button marked ″S″
on the Electronic clutch control panel to cycle through the three speed settings and select the
correct one for your specific application.
5.2. Reverse (counter clockwise) operation:
The electronic clutch has two different reverse modes: Full Reverse and Auto Break.
The Full Reverse mode is automatically activated when the direction switch (2) is put into the
reverse position. No LEDs on the Electronic clutch control panel should be illuminated. This
means that the clutch is set to full reverse mode. When the trigger is pushed the tool will
operate in reverse for as long as you hold down the trigger.
The Auto Break function is engaged by pushing the ″B″ button on the Electronic clutch control
panel (5). A red LED will illuminate in the third LED position to indicate that the Auto Break is
engaged. When the trigger is pushed the tool will start hammering in reverse. As soon as
the bolt breaks loose and there is no resistance the tool will immediately stop reverse motion.
This feature is meant for controlled loosening of lug nuts without backing fully off the stud.
Uncontrolled spinning can damage the treads on the end of the stud or bolt. To disengage break
just push the ″B″ button one more time and the red LED will turn off. Your tool is again in the full
reverse mode.
NOTICE: Both reverse functions only operate with the electronic clutch in the third speed
position.
This feature is unavailable in speed one and two.
6. Operating tips.
To install a socket, align the square drive with socket receiver and press on until locked
securely in place. To remove socket, pull the socket off while twisting back and forth to dislodge.
Caution: When removing socket or bits from tool, avoid contact with skin and use proper
protective gloves when grasping socket. Accessories may be hot after prolonged use.
Apply the power tool to the screw/nut only when it is switched off. Rotating tool inserts can
slip off. The torque depends on the impact duration. The maximum achieved torque results from
the sum of all individual torques achieved through impact. The longer the tool is engaged the
higher the accumulated torque value. Maximum torque is achieved in about 45 seconds. The
actual achieved tightening torque should always be checked with a torque wrench.
7. Environmental protection.
7.1. The machine, accessories and packaging should be sorted for environmental-friendly
recycling.
Do not dispose of power tools into household waste!