6 / 12
Swing The
Plane
PASS Reaction
Transmitter
Operaton
Reaction
Digital trims allow you to adjust the center
position of aileron, rudder, or elevator.
Each time the trim button is pressed, the
servo output will change one angle. If the
trim button is held, the output will scroll
in that direction until the trim button is
released or the output reaches its end.
When you hear a short "beep" sound, the
trim is centered.
Elevator
Trim
Rudder
Trim
Aileron
Trim
Digital Trim
Pitch Reaction
Yaw Reaction
Roll Reaction
Checking Control Movement
Elevator Stick
Rudder Stick
Aileron Stick
With the aircraft power on and the PASS
system in Expert, check the elevator,
rudder and aileron response as shown
above.
With the aircraft power on and the PASS
system in Partial or Full Assist, check the
elevator, rudder and aileron response as
shown above.
To prevent damage to the aircraft and surroundings, the throttle channel is locked each
time the transmitter is turned on. Follow the instructions below to unlock the throttle and
arm the motor.
CAUTION:
Keep your fingers and other foreign objects away from the prop while arming
the motor. Raise the throttle stick up to max position until you hear a "beep" sound.
Then pull the throttle stick down to min position until you hear a second "beep" sound.
The motor is now armed. When the throttle stick is raised again the motor will start.
Arming the Motor
