PROGRAMMING
4-26
4.6.4
Change Data Period
The datalog period can be programmed from 1 to 3,600
seconds (1 hour).
1. “Change Data Period?” is the fifth sub-menu item in
the Datalog sub-menu.
2. Press the
[Y/+]
key and the display shows “Datalog
Period = XXXX” with the left-most digit flashing,
where “XXXX” is the previously stored data log
period.
4.
To modify this period, starting from the left-most digit,
use the
[Y/+]
or
[N/-]
key to change the digit value and
press the
[MODE]
key momentarily to advance to the
next digit. The flashing digit will move to the next
digit to the right. Repeat this process until all 4 digits
of the new period are entered. Press and hold the
[MODE]
key for 1 second to exit data entry mode.
5.
If there is any change to the existing value, the display
will show “Save?” Press
[Y/+]
to accept the new value
or
[N/-]
to discard the changes and move to the next
sub-menu.
