RADWIN 5000 SCB Jet User Manual
Release 4.2
5-5
Log on to the HBS via a Server (Optional)
RADWIN Manager Setup
Figure 5-6: Log on window showing the user types
4. Choose a User Type. There are three:
•
An
Operator
can install and configure the sector.
•
An
Installer
can, in addition to functioning as an Operator, change the operating fre-
quency band (or regulation).
•
An
Observer
can monitor the sector, generate reports, but may not change any sec-
tor parameters.
5. Enter the password.
6. If you are a user with Read-Write permission, click
Options
to enter the Community
options if required.
7. If you have a direct connection to the target unit, click
OK
.
8. If you do not have a direct connection to the target unit, you can log on via a Server.
See the instructions for this in “Log on to the HBS via a Server (Optional)” on page
5-5. Once those are carried out, click
OK
.
5.5 Log on to the HBS via a Server (Optional)
If you do not have a direct connection to your target unit (for example, you must go through
a firewall), you may connect to it by checking the
Connect through Server
check-box (see
Figure 5-6
)
and entering its IP Address. Obtain this address from your Network Manager.
The SCB Jet supports SNMPv1 and SNMPv3 either separately or together. The log-on
procedure differs slightly between operation under SNMPv1 and SNMPv3. In what follows
below, we assume that SNMPv1 is in use. In
Table 5-2
at end of the section, we show the
difference between SNMPv1 and SNMPv3 at log-on time.
To set the SNMP version, use the
Settings
button in
Figure 5-5
. A log-on extension window
opens:
