The Monitor Log
Chapter 9
RADWIN 2000 User Manual
Release 2.5.40
9-12
Performance Monitoring Report Toolbar
You can use the toolbar to perform the actions described in the following table:
Setting Air Interface Thresholds
Use the Thresholds button on the Monitoring Performance Report toolbar to set the Air
Interface Thresholds:
Additional Air Interface
PM Data
Max RSL
The maximum of the receive signal level (measured in dBm).
Min RSL
The minimum of the receive signal level (measured in dBm).
Max TSL
The maximum of the transmit signal level (measured in dBm).
Min TSL
The minimum of the transmit signal level (measured in dBm).
RSL Threshold 1
The number of seconds in which the Receive Signal Level (RSL)
was below the specified threshold.
RSL Threshold 2
The number of seconds in which the RSL was below the
specified threshold.
TSL Threshold
The number of seconds in which the Transmit Signal Level
(TSL) was above the specified threshold.
BBER Threshold
The number of seconds in which the Background Block Error
Ratio (BBER) exceeded the specified threshold.
Additional Ethernet
Interface PM Data
Received Bytes
The number of Megabytes received at the specified port within
the interval
Transmitted Bytes
The number of Megabytes transmitted at the specified port
within the interval.
Throughput threshold
Seconds count when throughput fell below the threshold
Traffic threshold
Seconds count when actual traffic exceeded the threshold
TDM interface
Active seconds
The number of seconds that the configured TDM services are
active
Table 9-4: Action of the toolbar buttons
Command Button
Action
Get Data
Gather current performance monitoring data.
Save
Save current performance monitoring data to a file
Clear
Clear current performance monitoring data
Thresholds
Set Thresholds
Selection Pane
Toggle on/off left panel
Close
Closes the Performance Monitoring window
Table 9-3: Explanation of performance data
Data type
Reported Value
Explanation
