RADWAG PUE H315, User Manual

Page: 17 / 28

17
0.4.3. Cor - Entering correction values for linearity.
0.5. Adnn Additional modules activation
0.5.1. UFA YES, no
Wireless communication module: YES
- enabled, no - disabled.
0.5.2. I_O YES, no
IN/OUT module: YES - enabled, no -
disabled.
0.5.3. rS3 YES, no
RS485 module: YES - enabled, no -
disabled.
0.5.4. EtH YES, no
Ethernet module: YES - enabled, no -
disabled.
0.5.5. CL YES, no
4-20mA module YES - enabled, no -
disabled.
0.6. Boot Bootloader
0.7. dFLt - Default settings.
8.3. Device Defining
Defining the device at the production stage requires entering basic
balance/scale parameters: serial number, weighing device type, weighing
range.
Procedure:

Enter factory setup <P0.FAct> .

Go to <0.1.Glob / 0.1.1.duu> submenu, text <Cont?> is displayed.

Press key, text <nr FAc> is displayed, next you see window
for entering the serial number.

Enter the serial number, do it using the operation panel.

Press key to confirm, text <type> is displayed, next you see window
for balance/scale type selection.

Select balance/scale type, do it using operation panel (refer to factory
parameters table, section 8.2 of this manual).

Press key to confirm, weighing range window is displayed.

Select appropriate weighing range, do it using the operation panel.

Press key to confirm, <0.1.1duu> submenu is displayed.

Exit to home screen, to do it press key repeatedly.