12
SCOPIA
100
Gateway Quick Start
C
ONNECT
TO
THE
IP N
ETWORK
Use the supplied LAN cable to connect the Ethernet IP network
port on the front panel of the Gateway to a 10/100Base-T IP
network connection on your network hub.
C
ONNECT
TO
THE
ISDN N
ETWORK
(PRI
AND
BRI
G
ATEWAYS
ONLY
)
Use the appropriate cables to connect the PRI/BRI ISDN ports to
your PBX or direct PRI/BRI line connection.
C
ONNECT
TO
THE
S
ERIAL
I
NTERFACE
(S
ERIAL
G
ATEWAYS
ONLY
)
Line cables are attached to the Gateway via a DB-60 connector
that provides the serial line connection for the Gateway serial
ports. The cables are Y-type with split leads at the remote end. On
one side is either a V.35, RS-449 or EIA-530 connector. On the
other side is an RS-366 connector.
Gateway terminal adapter cables have either a DTE or a DCE
interface.
The Gateway can identify which type of cable has been
connected to its DB-60 serial ports. Cable configuration settings
are automatically displayed in the
Physical Interface
section of
the
Port
tabs. The automatically configured settings are shown in
DTE/DCE Interface Configuration Options on page 6
.
Note
If the
Physical Interface
section of the
Port
tabs is
displayed while you are connecting a cable to the Gateway, exit
the screen and then return to see the displayed cable
configuration settings.
C
ONFIGURE
THE
G
ATEWAY
Once you have assigned an IP address to the Gateway, you can
use the web interface to configure and monitor the Gateway.
Procedure
1.
In your web browser, enter the IP address or
device name of the Gateway.
For example:
http://125.221.23.44
Press
Enter
to display the
Login
screen.
