8
SCOPIA
100
Gateway Quick Start
5.
Insert the SCOPIA
100
Gateway unit into the 19-
inch rack.
6.
Fasten the brackets to the side rails of the rack.
7.
Make sure that the air vents at the sides of the
SCOPIA
100
Gateway unit are not blocked.
A
SSIGN
AN
IP
A
DDRESS
TO
THE
G
ATEWAY
The first time you install the Gateway, you assign an IP address
using a terminal cable connection. This allows you to access the
boot configuration menu of the Gateway. At power-up, the
Gateway goes through the following boot phases:
Auto-boot—The embedded operating system initializes
and displays basic information.
Configuration menu—A six-second countdown allows
you to enter the configuration menu.
Initialization—The Gateway completes its boot
sequence and is ready for operation.
Note
You can only perform serial port configuration of the
Gateway at startup, during a short period indicated by a
six-second countdown. Once the initialization phase is
complete, the only way you can enter the configuration menu is
by restarting the Gateway.
