NAME
MEMORY MODIFY
MM
M
COMMAND SYNTAX:
MM[n] < address> [; < options> ] < CR>
M [n] < address> [; < options> ] < CR>
FUNCTION:
The MM command is used to display and change memory.
If a data field is specified, memory locations beginning with
address are set equal to the value of the data. If a data field
is not specified, address and its contents are displayed on the
terminal. In either case a sub-command set is entered, and
operates as follows:
< address> < present data> ?[ < new data> ] < CR>
If new data is specified,
place in address ; display
the address and contents
of the next location
< address> < present data> ?[ < new data> ] < CR>
If new data is specified,
place in address ; display
the address and contents
of the previous location
< address> < present data> ?[ < new data> ] < CR>
If new data is specified,
put it in address ; display
address and its new
contents
< address> < present data> ?[ < new data> ].< CR>
If new data is specified,
put it in address ; then
leave the sub-command
mode
Address and present data are displayed by the monitor.
The remainder of the line is input by the user.
PME68-1B Manual
Page 96 Issue 5
Summary of Contents for PME 68-1B
Page 8: ...Figure 1 The PME 68 1B Board Photograph not available in PDF PME 68 1B Manual Page 2 Issue 5...
Page 12: ...Figure 4 Component Layout Diagram P5 P4 P3 BAT PME 68 1B Manual Page 6 Issue 5...
Page 56: ...Figure 14 Link Areas BAT PME68 1B Manual Page 50 Issue 5...