RADLEY RW2500, User Manual

Page: 25 / 102

18
RW SERIES
Squeeze the gun trigger and release the pressure after every failed recoil
attempt to start the pressure washer.
Note
DO NOT allow the unit to run for more than 2 minutes without the
gun trigger being pulled. This could cause overheating and damage to
the pump. When the temperature inside the pump gets too high the
thermal relief valve will temporarily open and release a spray of water
from the pump to lower the internal temperature.
4.2 STOPPING THE PRESSURE WASHER
Normal Operation
1. Engage the safety on the spray wand trigger.
2. Hold the engine power switch in the OFF position for a few seconds until
the engine fully stops.
3. Turn off water supply. Unlock the safety of the spray trigger and
depressurize the system by squeezing the trigger until the water stops
flowing. Then flip the safety lock back to the locked position.
4. Unplug all hoses.
Emergency Stop (All Models)
1. To stop the engine in an emergency, turn the power switch OFF
immediately.
1 2 3