Each transmitter has an individually assigned, unique ID code. In order to start
operation, the receiver must be linked with the ID code of the transmitter with
which it is being paired. Once the link is made, the ID code is stored in the
receiver and no further linking is necessary unless the receiver is to be used
with another transmitter. (For T/R set, the link is already done at factory. When
you purchased another receiver, this procedure is necessary; otherwise the
receiver will not work.
1.
Place the transmitter and the receiver close to each other within one (1) meter
2.
Turn on the transmitter.
3.
Check the LED that is placed on the back side of the transmitter to see if the
RF signal is active. When the green LED is ON solid, the RF signal is being sent.
4.
Turn on the receiver.
5.
Press down the "ID SET" switch for more than one second, and release the
switch. The receiver starts the linking operation.
6.
When the linking is complete, the LED in the receiver will change to solid
green. Please confirm that the servos will now operate by your transmitter.
LINK PROCEDURE
ID SET
16
