ELVN Elevon mixing
Intended for tailless, “flying wing” models such as delta wings and flying wings,
elevon mixing mixes channel 1 (aileron) to channel 2 (elevator) allowing the
elevons to operate in unison (as elevators) or in opposition (as ailerons). This
function requires that each elevon be operated by a separate servo.
To activate elevon mixing:
1. Connect the servo in the right wing to channel 2 (elevator) in the receiver and
connect the servo in the left wing to channel 1 (aileron) in the receiver.
PPM
Elvn
Inh
PPM
PPM
PPM
Elvn
Elvn
Elvn
On
50
1
%
CH
PPM
Elvn
50
2
%
CH
2. Enter the programming mode. Access the “ELVN” screen with the MODE key.
You cannot set “Elevon” mixing when “Flaperon” or “V-TL” mixing has already been
set. In order to enable “Elevon” mixing, you first need to cancel both “Flaperon” and
“V-tail” mixing.
3. Push the DATA INPUT lever upward. This will cause the flashing “INH” display to
change to a flashing “ON” display. Now the mixing is on.
4. Next you set the left wing to channel 1 (aileron) setting. Press the SELECT key to
display the
“
CH1” and flashing “%” sign. Use the DATA INPUT lever to set the
percentage of elevator travel rate from -100% to +100%
5. Next you set the right wing to channel 2 (elevator) setting. Press the SELECT key to
display the “CH2” and flashing “%” sign. Use the DATA INPUT lever to set the
percentage of rudder travel rate from -100% to +100%
6. Once this mix has been activated, move the servos to their full extremes to make certain they are not overdriving the
controls. If necessary, adjust the linkages to achieve the correct control throws.
13
