7
Se
tu
p
Setup
Powering Your Scanner
You can power your scanner with three AA batteries, or with an AC
or DC adapter (none included). For longest operation and best
performance, use alkaline batteries, or use nickel-metal hydride
(Ni-MH) rechargeable batteries.
Installing Batteries
1.
Turn off the scanner.
2.
Remove the battery compartment
cover.
3.
Set the battery type selector switch
inside the battery compartment to
ALK
for non-rechargeable alkaline
batteries or
Ni-MH
for rechargeable
batteries.
4.
Insert three AA batteries, matching
the polarity symbols (+ and –)
marked inside.
5.
Replace the battery compartment cover.
Charging Ni-MH Batteries
1.
Press and hold
POWER
to power off
the scanner.
2.
Make sure Ni-MH batteries are
installed and the battery type selector switch is set to
Ni-MH
.
3.
Plug an AC or DC power adapter (not supplied; see page 8) into
the
PWR
jack.
4.
Charging
indicates the batteries are being charged.
5.
When
Charge OFF
appears instead of
Charging
(about 14
hours for a full charge), the batteries are fully charged.
6.
Disconnect the scanner from the power source.
Ni-MH/ALK
Switch
AA
AA
AA
