Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Dual Caller..., Owner'S Manual

Page: 15 / 28

15
Operation
an error beep. Move closer to the base and
try again.
USING MUTE
To talk to someone in the room while using
the speakerphone without the person on the
other end of the phone line hearing your con-
versation, press
MUTE/DELETE
on the base.
Ckj[
Ckj[ Ckj[
Ckj[
appears on the base's display.
Press
MUTE/DELETE
again to resume your
phone conversation.
Note: When you talk over the speakerphone,
the party that speaks first has priority. If you
are making a call in a noisy environment, the
phone might pick up the noise and assume
you are still communicating, thus not switch-
ing back to the person you are speaking with.
If this should happen, press
MUTE/DELETE
so the noise will not be picked up by the
phone's microphone. Press
MUTE/DELETE
or
SPEAKER
to release when it is your turn to
speak.
SWITCHING BETWEEN THE
HANDSET AND THE
SPEAKERPHONE
To switch to the speakerphone while you are
using the handset, press
SPEAKER
on the
base. When you hear the conversation on
the speakerphone, press
TALK
on the hand-
set.
To switch to the handset while you are using
the speakerphone, lift the handset off the
base. If the handset is away from the base,
press
TALK
, then press
SPEAKER
.
USING BOTH THE HANDSET
AND THE SPEAKERPHONE
If someone else is using the speakerphone,
press
TALK
on the handset to join the con-
versation. If someone else is using the hand-
set, press
SPEAKER
on the base to join the
conversation.
9ed\[h[dY[
9ed\[h[dY[ 9ed\[h[dY[
9ed\[h[dY[
appears on the
base's display and CHARGE/IN USE lights.
During the call, one person can hang up and
let the call continue at the other keypad. Or,
both people can hang up to end the call.
Note: If you hear a high-pitched noise from
the base's speaker, the handset and the
base are too close together.
USING FLASH
Flash performs the electronic equivalent of a
switchhook operation for special services,
such as Call Waiting. For example, if you
have Call Waiting, press
FLASH
to answer an
incoming call without disconnecting the cur-
rent call. Press
FLASH
again to return to the
first call.
Note: If you do not have any special phone
services, pressing
FLASH
might disconnect
the current call.
USING REDIAL
To quickly dial any of the last three numbers
dialed on the handset, lift the handset and
press
REDIAL
. The last number dialed on the
handset appears below
2H[Z_Wbý'4
2H[Z_Wbý'4 2H[Z_Wbý'4
2H[Z_Wbý'4
. Press
RE-
DIAL
repeatedly until the desired number ap-
pears on the display, then press
TALK
.
To dial the last number dialed on the base,
press
REDIAL/PAUSE
on the base. The last
number dialed on the base appears on the
base's display. Then press
SPEAKER
. You
can redial only the last number dialed on the
base.
Notes:
• The redial memory is separate for each
keypad. You cannot redial a number you
dialed on the handset keypad using
REDIAL
on the base, and vice versa.