7
3
Use Your A/V Signal Sender
1.
Choose one of the 4 channels by sliding the channel
switch to set the transmitter and receiver to the same
channel.
2.
Turn on the transmitter and receiver. The power
indicators light red.
3.
Turn on the connected A/V source and TV. Point your
remote control (not included) at the receiver and
make a selection.
n
Note
: Most A/V devices work on 38kHz. Your
transmitter is set to 38kHz by default (indicated by
B
position of the
A/B Remote
switch). If the connected A/V
source does not respond to remote control commands,
change the setting and try again.
Side view of Transmitter
Side view of Receiver
Connect IR
extender
ON/OFF
Channel Switch
Must be set to
same channel.
Remote
Switch
15-332 -EN 033110.indd 7
4/6/2010 5:25:12 PM
