Radical Sportscars SR3 XX, Owner'S Manual, Page: 50 / 56

50 QD163-1
Clean the air filter and check the airbox bolts
Check the throttle cable, full throttle, tension.
Check all coolant pipes
11. Wiring
Check wiring in the engine bay for chaffing and signs of heat
Check HT leads
Check the condition of all connectors
Check the wheel speed sensor, gap (all four lights)
Check wiring behind the dash
Check all wiring is away or shielded from the exhaust
12. Paddleshift
Check paddleshift actuator bearings and length
Check blipper and shifting lines for leaks
Tighten valve block
13. Oil Filter
Drain the oil and remove the filter
Remove the 17mm drain bung and check the magnet for debris
Fill the car with new oil and fit new filter, re-Lockwire the bung when finished
Ensure the hose clip is fitted correctly onto the new filter
Dry crank the car to circulate the new oil
14. Run Up
Check coolant level
Start the engine check TPS and balance bodies
Warm the oil to 50deg
Hold the rpm at 4000rpm for 5 seconds and then turn engine off
Check the oil level and top up if needed
Check for any other signs of leaks
15. Spanner Check
Check all the following components:
Uprights, Wishbones, Pushrod’s, Rocker’s, Steering, Caliper’s, Pedal Box
Front Diffuser
Hose clips, Oil lines, Fuel lines, Water pipes
Air Jacks (Check for leaks)
16. Safety Systems
Check the seat belts are in date and are free from cuts and tears
Check the fire extinguisher is in date and full
17. Set Down/Set Up
Measure the car as it left the previous track and record
Set up the car for the next circuit
18. Clean The Car
Clean the interior, hoover the pedal box
Clean the bodywork
Polish the car
19. Re-fit Bodywork
Fit diffuser and bodywork ensuring lights are connected and working
Check cockpit controls
Check all the latches and dzus fasteners on the bodywork
Fit the rear tie downs