Radical Sportscars SR3 XX, Owner'S Manual, Page: 34 / 56

34
7.10 TPMS SETUP
Overview:
Each wheel sensor is coded to an individual car receiver.
Each sensor is also coded to a specific position (FL, FR, RL, RR).
Wheels need to always be fitted to the programmed corner for the system to work.
You can use alternative wheels on each corner, but they need to have sensors fitted with the same
programmed ID for that corner.
To program an additional sensor:
Step 1 Hold the programmer next to a working sensor you want to replicate (set 1).
Step 2 Press POWER to power on
Step 3 Press READ to read the ID number from the sensor.
Read ok
ID:X X X X X X X X : Y.YV
P:Z.ZBar T:WW°C
Not e d o w n t h is ID n u m b er .
Step 4 Press EXIT
Step 5 Hold TX for 5 seconds, this is takes you to the programming screen.
Step 6 Enter the ID number you have just taken down.
In D1 enter 13
In D2 enter the f ir s t t w o n u m b er s /let t er s of the ID
In D3 enter the 3r d a n d 4t h n u m b er s /let t er s of the ID
In D4 enter the 5t h a n d 6t h n u m b er s /let t er s of the ID
In D5 enter the 7t h a n d 8t h n u m b er s /let t er s of the ID
L ea v e D6 b la n k .
Step 7 Hold the programming tool next to the new sensor you want to program (set 2) and press the TX
button. It will say reading but it means transmitting! Once transmitted the screen will change to show the
programmed ID.
Step 8 Press Exit to exit this screen and exit again to get to the home screen.
Step 9 Check the ID is programmed correctly by re-reading the new sensor.