SP 1091Z10
BACK NUT
INLET FITTING
Countersunk Bolts (4)
Nuts (4)
Skimmer Mounting
Brackets (2)
Skimmer
Mounting
Plate
Skimmer
2" Male Adapter
Skimmer
Support
SKIMMER ASSEMBLY
RETURN ASSEMBLY
The return fitting is comprised of 3 pieces:
inlet fitting, SP 1091Z10 and back nut.
Install the return fitting by threading the
SP 1091Z10 into the inlet fitting. Place the
assembly into the pre-cut hole and thread
the back nut onto the SP 1091Z10 fitting.
All threaded connections should be prepared
using a combination of Teflon tape and marine
grade silicone. The return faceplate is attached
after the liner is installed.
Slide skimmer face through pre-cut skimmer
opening, keeping skimmer body on outside of
pool wall. Fasten assembly by inserting 2”
countersunk bolts through corner holes in
mounting plate, through pre-cut holes in pool
wall and through skimmer mounting
brackets, securing with hex nuts.
Tighten nuts to a snug fit.
Do not over tighten
as this will damage
the mounting plate.
Install skimmer support.
It is recommended that
2” PVC pipe be cut to size,
depending on installation.
Utilizing a 2” male adapter,
attach support to bottom of
skimmer as shown.
The skimmer faceplate
is attached after the
liner is installed.
If more inlets are desired, use a hole saw to cut proper opening.
Pool
Exterior
Pool
Interior
Summary of Contents for Keystone
Page 1: ...Keystone Pool Assembly Manual...
Page 2: ......
