Radialight LITHO, Installation And Operating Manual

Page: 6 / 20

6

This heater must be correctly installed in compliance with
the regulations in force in the country of installation.

Do not use this heater in the immediate surroundings of a
bath, a shower or a swimming pool;

Do not use this heater if it has been dropped;

Do not use if there are visible signs of damage to the
heater;

Use this heater on a horizontal and stable surface;

WARNING: Do not use this heater in small rooms when
they are occupied by persons not capable of leaving the
room on their own, unless constant supervision is provided.

WARNING: To reduce the risk of fire, keep textiles,
curtains, or any other flammable material a minimum
distance of 1 m from the air outlet.
2. Using the fan heater

For the correctly use of the fan heater, you have to extract the foot placed on the back of the appliance
as shown in picture 2. Just pull it until you ear a “click” and check that the foot is firmly locked in its
extracetd position.

The heater is fitted with a switch and an ambient thermostat as shown in picture 3.

The switch is used to control heater’s functioning selecting the off condition, cold air ventilation, warm
air (1000W) or hot air (1800W).

The heater is also equiped with an alarm light (picture 4) that switches on in case of
overheting/malfunctioning. It is not a functioning light and, consequentely, it will not switch on during
normal functioning.

Do not put anything on the heater to avoid any overheating/malfunctioning (picture 5).
Using the thermostat

In a room with a temperature exceeding 30°C, the thermostat does not turn on the fan heater even if it
is at maximum.

Vice-versa, in a room with a very low temperature (below 5°C), it is normal that the thermostat keeps
the heater constantly on, even if it is at minimum.

To optimise use of the thermostat, proceed as follows:
- turn the thermostat knob to maximum and wait until a comfortable temperature is reached;
-
then turn the thermostat knob anti-clockwise unt
il you hear a “click” and the heater turns off;
-
turn the thermostat knob clockwise just a little;
- in this position, the thermostat will maintain the selected ambient temperature.
3. Filter

This product is fitted with a filter to protect the heating element from dust and dirt.

The filter is removable to be easily cleaned with water.

To remove the filter just unlock the tab by pressing on it and pull towards you as shown in pict. 6.

To keep the heater in perfect condition, clean the filter once every six months REMEMBERING TO
PUT IT BACK AGAIN AFTERWARDS.