Page 18 from
24
Instructions rad3_bullitt_kids_box_2022 09
12
Drill on the right side mirror-inverted to the left side shown here. Use a 6, better 6.5 mm drill bit.
Hold a piece of wood or similar against the opposite side to avoid splintering (risk of injury!).
Ideally, you should fix the wood with a screw clamp to avoid injuries!
Dimensions 40 and 42 mm refer to the extension of the long straight edge on the left.
Dimensions 22 and 62 r e f e r t o t h e e x t e n s i o n o f t h e l o n g s t r a i g h t edge at
the top.
Use the M6x20 flange head bolts, the large K-washers on the outside, the small ones on the inside.
Now assemble the linkage.
By the way, this is designed with the separating points so that it fits folded into the box. Slide
the long rods into the guides from below with the straight ends first. This will go quite tight the
first time - that is normal.
If you want to remove the rods later, NEVER pull on the lower end but push gradually from the
top downwards. Otherwise the rubber inside will tear!
Fig. 14-3:
Threading large rods
Fig. 14-4:
Threading crossbar, is
usually already
mounted
(small viewing window is
still prototype)
If not already fitted, now insert the sail batten at the top into the "shoes" on the right and left,
you must bend it slightly for this.
Then close the Velcro fastener.
