Rad Power Bikes RadRhino, Owner'S Manual

Page: 9 / 33

9
3) After tightening the finger nut on the seat post quick release properly, close the quick release lever by swinging the lever
back 180 degrees until it looks like the image below and the saddle cannot move up, down or to the left or right.
Before using the bike, check that the saddle post quick release skewer is closed and tightened properly. Check that it is correctly
fitted before every ride and after every time the bike is left unsupervised, even for a short time. Otherwise, the saddle post
may come loose and result in loss of control and serious injuries.
For most users, the saddle height should be set by placing the ball of your foot on the pedal when the crank is at it’s lowest point.
Your leg should almost be fully extended.
Adjusting the Saddle Position and Angle
To change the angle and horizontal position of the saddle:
1) Undo the Allen head bolt underneath the saddle on the saddle clamp positioned immediately underneath the saddle,
above the rear wheel.
2) You can now move the saddle backwards or forwards in the guide and adjust the angle of the saddle. A horizontal
position is desirable for most riders. There are white limit markings on the saddle rail, which show the minimum and
maximum horizontal movement allowed for this component, do not exceed these limits.